15-inch WyzeProbe for Secondary Ignition and COP

Scope each COP cylinder, one at a time, and quickly with the WyzeProbe!
This 15-inch probe makes it easier to access the coils.

Works on all labscopes! Industrial and automotive.

Test lead sold separately, see below.

Does more than just COP
* Superimpose secondary ignition patterns on conventional ignition by simply placing probe on the ignition coil or coil wire.
* Superimpose secondary ignition patterns on HEI (Coil-in-Cap) ignition, by simply placing probe on distributor cap center position.

Does more than just Secondary Ignition
* Alternator diode pattern: place WyzeProbe tip on rear (ground) case of alternator. Instead of fighting to get to the positive output terminal of alternator.
* Injector on time: provides a quick way to verify on time and mechanical problems on some injectors used with with COP ignition.

* works on most 2- and 3-wire coil on plug systems. Coil consturction may prevent capturing a signal on some 3-wire and 4-wire coils.
* Faster than scoping the primary!
* Find misfires that don't set trouble codes without scraping your knuckles or getting dirty.
* Fully shielded to probe tip.
* Capacitive protected to avoid damage to your test equipment.
* Works on all labscopes!
* Works with Snap-on Vantage (ignition patterns only).
* No batteries required!
* Test lead sold separately, see below.

Contents
* 15-inch WyzeProbe for Secondary Ignition and COP

Test Leads
The WyzeProbe can be used with practically any oscilliscope. Select the the appropriate test lead to to connect the probe to your scope:
- for scopes with BNC inputs (Pico, OTC, Interro)
- for scopes with Banana inputs (Snap-on, UEI)