Home » COP Secondary Paddle Lead (Capacitive)
COP Secondary Paddle Lead (Capacitive)
COP Secondary Paddle Lead (Capacitive)
COP Secondary Paddle Lead (Capacitive)
COP Secondary Paddle Lead (Capacitive)
COP Secondary Paddle Lead (Capacitive)
COP Secondary Paddle Lead (Capacitive)

COP Secondary Paddle Lead (Capacitive)

AES#: 01-16-Blk-1ft-BNC
(0)
In stock
$70.00

Easily scope COP and DIS ignition systems using the AES COP Secondary Paddle Lead (Capacitive).

This rugged 10-foot long, capacitive secondary lead includes a flexible yet sensitive 'paddle' that picks up the secondary signal from compatible COP system on the road today. The thin 'paddle' gets into tight spots that no bulky probe can. Coil construction can prevent capturing a waveform with any paddle probe. 4-wire and some 3-wire coils will not produce usable waveforms.

DIS is even easier, touch the 'paddle' to any exposed plug wire to pickup the secondary signal.

To protect from possible high-voltage arcs the lead includes a ground connection that includes a high-quality, gator clip with a large jaw.

The AES COP Secondary Paddle Lead (Capacitive) is attenuated 1,000:1, this means that each 1V displayed on your scope represents 1000V in the secondary. - Jorge from AESwave.com adds, “This is approximate. There are so many different ignition systems and test points that it is impossible to have a specific calibration. In this case, the 1000:1 is more reflective of the circuit that is used inside the probe to attenuate the signal.”

Use the The AES COP Secondary Paddle Lead (Capacitive) with both analog and digital scopes to view waveforms one cylinder at a time on these systems:
- COP
- DIS (EI)

Scope Setup
General instructions for setting your scope to display a COP and DIS signal are included with the test lead.

Test Lead Configuration
Standard lengths are 6-ft and 10-ft long.
If you would like a custom length, please contact us to place the order.

Connection to scope: The test lead is configured with either BNC or banana plugs for connecting to your scope (tell us which connector you need when placing your order). For scopes with banana plug inputs, the lead's ground banana plug is stackable to allowing other channels to access the scope's ground when using multiple channels.

Connection to vehicle: The test lead has two connections to make on the vehicle: Large gator to vehicle ground and paddle for signal.
  • Ignition Coil Over Plug(COP)